1
J
R-4108.A
REASSEMBLING PROCEDURE
< Reassembling
me
X
and
Y
Movement
> (Fig.
s.
6)
.
1)
Place the stage upper
pia
te
Q upside down tilting on a table. The guide block @ ( or @ )
whichever that has been left fixed on (j) makes the basis
of
the reassembling.
Place the rails @
x2
-+
the
rollers@x4
.....
the
retainer(Dx
1 lubricating with lubricant G202
on the groove
of
the guide block @ .
2)
P1ace
the stage
baseplate@
on (D facing its rail groove to the
rail
groove
of
@ . Put the rails,
rollers and retainer
@
x2
-@x4
-(})x
1 on the other rail groove
ofG)
applying G202
oil.
Place the guide block @
e@)
on
CD
facing its rail groove to the rail groove
of(D.
Fix the
guide block
@ to the upper plate Q by screwing the screws @ x
J.
3)
Make
sure that no slack
in
the X direction
is
found at the both end of the moving range
of
the upper
plate(D
on the base plate
{]).
If
any slack
is
found, release slightly the
screws@
xJ
to adjust the guide block @ (or
@)
that has been just reassembled by the procedure 2).
4)
P1ace
the whole stage assembly tilting on the work table
soas
the X rail groove
of(D
is
on the
upperside.
Put
@x2
-•{V•4
-(2),.
1 on the above groove applying G202 oi!.
5) Apply
G202
oi!
to
the both rail grooves
ofG)
on which put @
x4,
then place 0 on
G)so
as
one rail groove
ofÜ
faces to the groove
of(D.
Put@x
4 -(V. 1 on the other rail groove
of@.
6) Put @
x2
on 8 rail groove applying G202 oil and place the latter to
face
the groove
ofO.
Then,
fix@to@,@
screwing the
screws@x4.
7) Fix the vemier scale @ and its
seat@
to the stage
base(D
by the
screws@
x2.
8) Fix the handle assembly to the guide block @ or @ and adjust the meshing
of
the pinion and
the X rack
@ releasing the screws
@x
2 slightly.
-10-
To Next Page
Loading...
Need help?
General
