Nilfisk-Advance Advance SC5000

8Service Manual – SC5000 03 - General Information
Parts And Service
Repairs should be performed by an Authorized Nilsk/Advance Service Center that employs factory-trained
service personnel and maintains an inventory of Nilsk/Advance original replacement parts and accessories.
Diagnostic and Service Tools
In addition to a full set of metric and standard tools, the following items are required in order to successfully
and quickly perform troubleshooting and repair of Advance commercial oor cleaning equipment.
• Digital voltmeter (DVM) with DC current clamp
• Hydrometer
• Battery load tester for checking batteries
• Set of torque wrenches
These tools are also available from Nilsk-Advance, Inc.:
• Vacuum water lift gauge, p/n 56205281.
Conventions
All references to right, left, front and rear in this manual are as seen from the Operator’s position.
Modications
Modications and additions to the cleaning machine which affect capacity and safe operation shall not be
performed by the owner or user without prior written approval from Nilsk Inc. Unapproved modications
will void the machine warranty and make the owner/user liable for any consequential damages.
Nameplate
The machine nameplate is located on the rear of the steering column.
The nameplate contains important identication information which
is needed when ordering parts, such as the machine Model Number
(Part No.) and Serial Number.
Model & Sub Model
1234567890123
Qtr/Yr
Gross Veh. Wt
Machine PN
Machine Voltage
Nameplate