Service Manual: SC750, SC800, SC 750 ST, SC800 ST
Form Number 56043150 Page 7
• Before performing any service funcon, carefully read all instrucons pertaining to that funcon.
• Do not leave the machine unaended without rst turning the key switch o (O), removing the key and securing
the machine.
• Turn the key switch o (O) and remove the key, before changing the brushes, and before opening any access
panels.
• Take precauons to prevent hair, jewelry, or loose clothing from becoming caught in moving parts.
• Use cauon when moving this machine in below freezing temperature condions. Any water in the soluon or
recovery tanks or in the hose lines could freeze, causing damage to valves and ngs. Flush with windshield
washer uid.
• The baeries must be removed from the machine before the machine is scrapped. The disposal of the baeries
should be safely done in accordance with your local environmental regulaons.
• Do not use on surfaces having a gradient exceeding that marked on the machine.
• All doors and covers are to be posioned as indicated in the instrucon manual before using the machine.
General Machine Description
The “SC” (SC750, SC800, SC75 ST and SC800 ST) machines are baery powered walk behind oor scrubbers designed to
clean at, hard surfaces. They are powered by a 24 volt baery pack. They have one controller that operates the scrub
and vacuum funcons and another that operates the drive system. They can be equipped with either a “Disc” scrub deck
or a “Cylindrical” scrub deck.
Nameplate
The nameplate contains important idencaon informaon which will be needed when ordering parts: Model (Name),
Part No. (Part number of the machine which is oen referred to as the “Model Number”), and Serial Number.
To Next Page
Loading...
Need help?
General
