Noble UH30-E - Operation Procedures; Startup and Basic Operation

13
07610-004-45-09-D
OPERATING INSTRUCTIONS
OPERATION
Before operating the machine, verify the following:
1. Strainers are in place and clean.
2. Wash and rinse arms are screwed securely into place and end-caps are tight.
3. Wash and rinse arms rotate freely.
4. Chemical levels are correct.
To energize the machine, turn on the power at the service breaker. The voltage should
have been previously veried as correct. If not, the voltage must be veried before
energizing the machine.
1. Press the “Power” button.
2. The machine will automatically begin the fill cycle.
3. Once the wash tub is filled, the machine displays "HEATING."
4. Wait for wash temperature to display at least 155 °F and for the status to display
"READY" before operating the machine.
PREPARATION
POWER UP
FILLING THE
WASH TUB
155 F
READY
CYCLE 1