07610-004-45-09-D
18
DELIMING
OPERATION
In order to maintain the machine at its optimum performance level, lime and
corrosion deposits must be removed. The frequency for deliming will be based on
water conditions. A deliming solution is available from your chemical supplier. Read
and follow all instructions on the label.
To delime machine:
1. Remove the rinse arms and place in sink with deliming solution (leave for the
amount of time recommended by the chemical supplier).
2. Replace the rinse arms.
3. If machine is full of water, close door, press the "Power" button, and allow
machine to drain and shut-o.
4. Follow the Filling the Wash Tub section of this manual.
5. Open the door and add the amount of deliming solution recommended by the
chemical supplier.
6. Close the door and press the "Delime" button on the display. The status will
display "DELIME."
7. Press the "Start" button.
8. The machine will delime, drain, and rell.
9. Wait ve minutes, then inspect the machine. If the machine is not delimed,
run again.
10. When clean, press the "Delime" button. The status will display "READY."
11. Run the machine through two regular cycles to remove residual deliming
solution.
12. The machine is now ready for normal operation.
DELIMING
If this machine is equipped
with an SPS and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, see the
Plumbing Options page.
155
F
DELIME
ON
To Next Page
Loading...
