Note: Your device may indicate that your
message was sent to the message center number
programmed into your device. Your device may not
indicate whether the message is received at the
intended destination. For more details about
messaging services, contact your service provider.
If an interruption occurs while the message is being
sent, the phone tries to resend the message a few times.
If these attempts fail, the message remains in the
Outbox folder. To cancel the sending of the messages
in the Outbox folder, scroll to the desired message, and
select Options > Cancel sending.
Postcards
With the postcard messaging service (network service),
create and send postcards that may contain an image
and a greeting text. The postcard is sent to the service
provider using multimedia messaging. The service
provider prints the postcard and sends it to the postal
address given with the message. MMS must be activated
before this service can be used.
Before you can use the postcard service, you must
subscribe to the service. To check the availability and
costs and to subscribe to the service, contact your
service provider.
To send a postcard, select Menu > Messaging > Create
message > Postcard. Fill in the address; mandatory
editor fields are marked by a *. Scroll to the image field,
select Insert and an image from the gallery, or New
image to insert a recent image; then write your
greeting text. To send the message, select Send.
Flash messages
Flash messages are text messages that are instantly
displayed upon reception. Flash messages are not
automatically saved.
Write a flash message
Select Menu > Messaging > Create message > Flash
message. Enter the recipient’s phone number and
write your message. The maximum length of a flash
message is 70 characters. To insert a blinking text into
the message, select Options > Insert blink char. to set
a marker. The text after the marker blinks. To end the
blinking text range, insert a second marker.
Read and reply to a flash
message
A received flash message is indicated with Message:
and a few words from the beginning of the message.
To read the message, select Read.
To extract numbers and addresses from the current
message, select Options > Use detail.
To save the message, select Save and the folder in
which you want to save it.
24
Messaging
Cyan
To Next Page
Loading...
Need help?
General
