7210 SAS-M CHASSIS INSTALLATION GUIDE Configuring the System
Issue: 07 3HE 10089 AAAA TQZZA Edition 01 55
booting your 7210 SAS-M, please refer to the System Basics Guide. Figure 15
shows the network diagram used in the example below. Additionally, you may want
to store the TiMOS image on the internal flash if you want to boot from the flash later.
You will need the following:
• An FTP server
• The TiMOS software image
• A PC with a serial port and Hyperterminal
• An RJ-45 serial cable that connects the console port of the 7210 SAS-M to
the serial port of PC
• A network cable to connect the 7210 SAS-M to the network
Prepare the setup as shown in the diagram above. Ensure that the console settings
are set as shown in Console Connection on page 65.
When you are done, power on the 7210 SAS-M.
Using the uplink port to boot the 7210 SAS-M from the network:
Resetting...OK
ø
Nokia 7210 Boot ROM. Copyright 2000-2009 Nokia.
All rights reserved. All use is subject to applicable license agreements.
Running POST tests from ROM
Testing ROM load area...done
Relocating code...Jumping to RAM
Performing second stage RAM test....passed
Board Serial Number is 'SN12345678'
Bootlog started for Version V-1.0.R1
Build V-1.0.R1 bootrom/mpc 7xxx
Built on Thu Jan 15 14:55:59 IST 2009 by builder in /builder/ws/panos/main
Since the router does not ship with a BOF, it will show the default settings.
Looking for cf1:/bof.cfg ... not found
Could not find bof.cfg on any of the local drives.
Default settings:
------------------------------------------------------------------------------------
-------------
Contents of Boot Options File on cf1:
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/1
To Next Page
Loading...
Need help?
General