Troubleshooting
72
7210 SAS-M CHASSIS INSTALLATION GUIDE
3HE 10089 AAAA TQZZA Edition 01 Issue: 07
6.4 In-Band Access
You can access the management agent in the switch from anywhere within the
attached network using Telnet or network management software tools. However, you
must first configure the switch with a valid IP address, subnet mask, and default
gateway.
If you have trouble establishing a link to the management agent, check to see if you
have a valid network connection. Then verify that you entered the correct IP address.
Also, be sure the port through which you are connecting to the switch has not been
disabled. If it has not been disabled, then check the network cabling that runs
between your remote location and the switch.
Note: The management agent can accept up to seven simultaneous Telnet sessions. If the
maximum number of sessions already exists, an additional Telnet connection will not be
able to log in to the system.
To Next Page
Loading...
Need help?
General