Nokia 7210 SAS-M Series User Manual

7210 SAS-M CHASSIS INSTALLATION GUIDE Configuring the System
Issue: 07 3HE 10089 AAAA TQZZA Edition 01 65
5.3 Establishing Router Connections
Access your newly installed switch two ways:
• Console Connection on page 65
• Telnet Connection on page 66
5.3.1 Console Connection
The Console port on the front of the 7210 SAS-M is an RJ-45 connector. To establish
a console connection, you need the following:
• An ASCII terminal or a PC running terminal emulation software set to the
parameters shown in the table below
• The included RJ-45 serial cable
To establish a console connection:
Step 1. Connect the terminal to the Console port on the front panel using the serial
cable.
Step 2. Power on the terminal.
Step 3. Establish the connection by pressing the <Enter> key a few times on your
terminal keyboard.
Step 4. At the prompt, enter the login and password.
The default login is admin.
The default password is admin.
Table 12 Console Configuration Parameter Values
Parameter Value
Baud rate 115 200
Data bits 8
Parity None
Stop bits 1
Flow control None

Nokia 7210 SAS-M Series Specifications

General

Brand	Nokia
Model	7210 SAS-M Series
Category	Switch
Language	English