Installation Site Assessment
92
7210 SAS-M CHASSIS INSTALLATION GUIDE
3HE 10089 AAAA TQZZA Edition 01 Issue: 07
10.4.3 Specific Characteristics of the Installation Site
Does the installation site exhibit characteristics that may require upgrade or repair?
Aluminum manufacturing
Ore smelting
Tobacco smoke
Battery manufacturing
Mountains near a coastline
High humidity regions
Fossil fuel use, such as open fires used by locals for cooking or
burning farming byproducts
Table 20 Checklist 2: Local Risk Factors (Continued)
Risk Factor Yes No
Table 21 Checklist 3: Specific Characteristics of the Installation Site
Characteristic Yes No
Is the installation site in a room that is part of the building HVAC
system?
Does the installation site have protection to prevent ingress of dust?
Does the installation site have protection to prevent ingress of
pollution?
Does the installation site have protection to prevent ingress of
humidity?
If outside air is brought in for ventilation, does it pass through a filter?
If outside air is brought in for ventilation through a filter, is the type and
rating of the filter appropriate to the environmental conditions?
Does the site have an air conditioner?
Is the rating and capacity adequate for the space?
Is there proper drainage of water from the air conditioner?
Does the site have a dehumidifier?
Is the rating and capacity adequate for the space?
Is there proper drainage of water from the dehumidifier?
To Next Page
Loading...
Need help?
General