7210 SAS-M CHASSIS INSTALLATION GUIDE Configuring the System
Issue: 07 3HE 10089 AAAA TQZZA Edition 01 67
5.3.2.1 Running Telnet
After the IP parameters are configured, you can access the CLI command line with
a Telnet connection. To establish a Telnet connection, run a Telnet program and
issue the Telnet command, followed by the IP address:
The following displays an example of a Telnet login:
C:\>telnet 10.10.10.25
Login: admin
Password: ########
ALU-1#
5.4 Restarting the Router
To reset the switch, perform the following procedure:
Step 1. Press and hold the Alarm Cut Off (ACO) button.
Step 2. Press and hold the Reset button for a minimum of 10 seconds before
releasing the Reset button.
Step 3. Release the ACO button.
To Next Page
Loading...
