Configuring the System
54
7210 SAS-M CHASSIS INSTALLATION GUIDE
3HE 10089 AAAA TQZZA Edition 01 Issue: 07
New Settings
------------
primary-image cf1\both.tim
primary-config cf1:\config.txt
#uplinkA Port Settings:
uplinkA-port 1/1/10
uplinkA-address 10.135.4.172/10
uplinkA-vlan 0
uplinkA-route 10.10.170.0/10 next-hop 10.135.4.1
#System Settings:
wait 3
persist off
console-speed 115200
Do you want to overwrite cf1:/bof.cfg with the new settings? (yes/no):
Type yes and press Enter. The 7210 SAS-M should boot now.
Primary image location: cf1:/both.tim
Loading image cf1:/both.tim
Version B-3.0.B5-85, Wed Apr 20 14:32:04 IST 2011 by builder in /builder/
3.0B5/panos/main
text:(25059814-->122242456) + data:(3179598-->18748616)
Executing TiMOS image at 0x100000
After the 7210 SAS-M boots up, you should see the following prompt:
All rights reserved. All use subject to applicable license agreements.
Built on Wed Apr 20 14:32:04 IST 2011 by builder in /builder/3.0B5/panos/
main
Login:
Both the default username and password are admin. Log in to the 7210 SAS-M. To
establish either console connection or Telnet connection to the 7210 SAS-M after a
successful boot, please see "Establishing Router Connections" on page 65.
5.2.1.2 Booting From the Network
There are several ways to boot the 7210 SAS-M from the network. User has options
to use one of the front panel ports (refered to as uplinkA and uplinkB in the display
output shown below) or the out-of-band ethernet management port (refered to as eth-
mgmt port in the display output shown below) to boot the 7210 SAS-M from the
network. By default, the out-of-band ethernet management port is disabled. User
needs to enable it before using it for manual boot. The example below shows how
this can be done. The example described below shows how to boot the 7210 SAS-
M using FTP servers and the manual boot process. For more information about
Note: The SYS LED will be green when the device has successfully completed the boot
process and is running normally.