Nokia 9500 - Page 84

and create new network IDs. Using the correct
network ID ensures that the data traffic is routed
directly to the desired destination network.
Especially VPN (virtual private network) software
may restrict data traffic for a certain destination
network. Network ID can be used to filter
Internet access points when establishing an
Internet connection.
• GPRS access point name (for GPRS only)—If
you are not using a default Internet access point,
define a name for the access point. You can
obtain the name from your network operator or
service provider.
• Telephone number (for GSM data only)—Type
the modem telephone number of the Internet
access point.
• Password prompt—Change this to Yes if you
must write a new password every time you log
on to a server, or if you do not want to save your
password to the device.
• User name—Type a user name if required by
the service provider. The user name may be
needed to make a data connection, and is usually
provided by the service provider. The user name
is often case-sensitive.
• Password—A password may be needed to
connect to the Internet, and is usually provided
by the service provider. The password is often
case-sensitive.
4. After defining the settings, press Advanced to
define advanced settings, if necessary. Otherwise,
press Finish or Done to exit the setup wizard.
Configuring advanced Internet
access point settings
Press Advanced when you have finished setting up the
basic Internet access point settings. The pages and
options available depend on the connection type you
have selected.
IP configuration page
Note that the two protocols (IPv4 and IPv6) require
slightly different settings.
• Network type (for GPRS only)—For a GPRS
connection you must specify which protocol you
want to use.
• Auto retrieve IP—If you select Yes, the IP address
is obtained automatically from the server. This
setting is also called ‘dynamic IP address’.
• IP address—The IP address of the device. If the IP
address is obtained automatically, then you are not
required to enter details here.
• Auto retrieve DNS—If you select Yes for the IPv4
protocol, the DNS (domain name server) address is
obtained automatically from the server. The
respective value for the IPv6 protocol is Well
known. DNS is an Internet service that translates
domain names such as www.nokia.com into IPv4
addresses like 192.100.124.195, or IPv6 addresses
like 3ffe:2650:a640:1c2:341:c39:14. If you select No
for the IPv4 protocol, or Manual for the IPv6
protocol, you need to specify the IP addresses for the
primary and secondary DNS servers.
84
Control panel
file:///C:/USERS/MODEServer/tkoikkal/864507/RA-2_Erin/en/issue_1/ra-2_erin_en-us_1.xml Page 84 Jul 2, 2004 11:32:12 AMfile:///C:/USERS/MODEServer/tkoikkal/864507/RA-2_Erin/en/issue_1/ra-2_erin_en-us_1.xml Page 84 Jul 2, 2004 11:32:12 AM