Nokia WiFi Beacon 6 Product Guide
Issue: 01 3FE-47429-AAAA-TCZZA 49
Danger 2 — Make sure all sources of power are turned
off and have no live voltages present on feed lines or
terminals. Use a voltmeter to measure for voltage before
proceeding.
Danger 3 — Always contact the local utility company
before connecting the enclosure to the utilities.
Caution — Keep indoor devices out of
direct sunlight.
Prolonged exposure to direct sunlight can damage the unit.
Note 1 — Observe the local and
national laws and regulations that may be applicable to this
installation.
Note 2 — Observe the following:
• The device should be installed in accordance with the
applicable requirements of the NEC or CEC. Local
authorities and practices take precedent when there is
conflict between the local standard and the NEC or
CEC.
• The device must be installed by qualified service
personnel.
• Indoor units must be installed with cables that are
suitably rated and listed for indoor use.
• See the detailed specifications in the Beacon 6
(HA-0336G-A) unit data sheet for the temperature
ranges for these devices.
Replace a Beacon 6 (HA-0336G-A)
7.6 Procedure
Use this procedure to replace a Beacon 6 (HA-0336G-A).
To Next Page
Loading...
