Nokia WiFi Beacon 6 Product Guide
3FE-47429-AAAA-TCZZA Issue: 01
1 Power down the unit by using the on/off power switch. See Figure 10 for the connections on
the Beacon 6 (HA-0336G-A).
Figure 10 Beacon 6 (HA-0336G-A) connections
28231
2 Disconnect the WAN, Ethernet, and power cables from the Beacon 6 (HA-
0336G-A); see Figure 10 for the connector locations on the Beacon 6
(HA-0336G-A).
3 Replace the Beacon 6 (HA-0336G-A) with the new device. The device
can be placed on any flat surface, such as a desk or shelf.
4 Connect the Ethernet cables directly to the RJ-45 ports; see Figure 10 for
the location of the RJ-45 ports.
5 Connect the WAN cable directly to the RJ-45 port; see Figure 10 for the
location of the RJ-45 WAN port.
Replace a Beacon 6 (HA-0336G-A)
6 Connect the power cable to the power connector.
ON/OFF RESET
PS
LAN 1 LAN 2
AN
POWER
LAN 3
ON/OFF R ESET
PS
LAN 1 LAN 2
WAN
POWER
LAN 3
To Next Page
Loading...
