Nokia WiFi Beacon 6 Product Guide
Issue: 01 3FE-47429-AAAA-TCZZA 51
Note — Observe the following:
• Units must be powered by a Listed or CE approved and marked
limited power source with a minimum output rate of 12 V dc, 2 A.
The polarity of the power adapter plug must match the Beacon 6
(HA-0336G-A).
7 Power up the unit by using the On/Off power button.
8 Verify the LEDs and voltage status.
9 Activate and test the services.
10 If necessary, reset the Beacon 6
(HA-0336G-A).
Note — Resetting the device will
return all settings to factory default values; any configuration
customization will be lost.
i Locate the Reset button on a Beacon 6 (HA-0336G-A) as shown in
Figure 10.
ii Insert the end of a straightened paper clip or other narrow object into
the hole in the Reset button to reset the device.
11 STOP. This procedure is complete.
To Next Page
Loading...
