Nordson 3100V Series Customer Product Manual

B
3-4
Tank
Disassembling
the
Tank
and
Manifold
@ontd.)
5.
Remove
the screws
on the bottom of the hose-end
panel.
Swing the
panel
and wire
harness
away
from
the unit.
6.
lf
the unit is
attached to a support
platform,
remove any anchoring
bolts.
7.
See Figure B
3-3.
Remove
the RTD,
thermostat, and
ground
wire
(if
present)
from the tank.
\s
4130929A
Fig. B
3-3 Removing
an RTD and Thermostat
(typical)
8.
Tilt
the unit back
at an angle to
gain
access
to the base and
remove
the screws and washers
that attach the manifold
to the base. Return
the
unit to the level
position.
NOTE: Ask
an assistant to help
you
tilt the unit and support it while
you
remove
the screws and washers.
9. Pull
the tank and manifold away from
the unit. The spacers between
the manifold and
the base may come loose at this
time.
lf they
do
not,
remove them
by
hand.
10. Disconnect
the tank heater
wires.
11.
Carefully remove
all insulation.
12.
Separate the tank cover
and
gasket
from the tank.
13. Remove the
tank strainer from inside the
tank.
83EN-05-[3V-4-AXXX]-2
41-3000v
lssued 5/00
e000 Nordson Corporallon
All
rights
reserved

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English