Nordson 3100V Series Customer Product Manual

B
3-6
Tank
Reassembling
the Tank
and
Manifold
@ontd;
4. lnsert
the manifold washers
and screws in the bottom
of
the
manifold
and
tighten them finger
tight only. Then tighten the screws in
the
sequence shown
in Figure B
3-5.
Tighten
the screws to
5.4-6.8
N.m
(4-5
ft-lb).
Fig. B
3-5 Correct
Sequence for Tightening Manifold
Screws
5.
Turn
the tank and manifold
over so that the tank's
open side
is
up and
wrap
the
insulation
around the
tank and manifold.
Use
high-temperature
duct tape to secure
the
insulation.
6.
Reconnect
the heater wires
to the tank heater connections.
7. Hold
the spacers in
place
and attach the tank and manifold to the
base of the unit with
the screws
and
washers removed
earlier. lt may
be necessary
to tilt the
unit to
gain
access to the bottom of the base.
Tighten the
screws to 10.9-13.6 N.m
(8-10
ft-lb).
NOTE: Be
sure
you
do not
pinch
the heater wires when
you
are
securing the
tank and manifold
to
the
base.
NOTE: To
ease assembly,
you
can cut the heads off of four M8
screws
that are longer than
the spacers
(do
not use the screws
supplied with
the service
kit). Loosely thread the cut screws into the
tapped holes
in the bottom of
the manifold.
Slip
the spacers over the
screws. This
will keep the spacers
in line until
you
are
ready to install
the supplied
screws. When
you
are ready to install the supplied
screws, remove
the cut screws. Ask
an assistant to help
you
tilt the
unit
and support it while
you
replace the screws
and
washers.
o
o
o
o
o4
oc
o1
a2
o5
41306044
83EN-05-[3V-4-AXXXI-2
41-3000y
lssued
5/00
@
2000
Nordson
Corporalion
All rights
reserved

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English