Nortel BayStack 410 24T - Logout

Using the Console Interface
309985-B Rev 00
3-117
Logout
The Logout option (accessed from the main menu) allows a user working at a
password-protected console terminal or in an active TELNET session to terminate
the session.
The Logout option works as follows:
• If you are accessing the BayStack 410-24T switch through a TELNET
session, the Logout option terminates the TELNET session.
• If you are accessing the BayStack 410-24T switch through a
password-protected console terminal (connected to the console/comm port on
the switch), the Logout option displays the console-terminal password prompt
(Figure 3-53
). If RADIUS authentication is enabled, the password field is
preceded by a username field. You must enter the correct password (and
username, if applicable) to access the CI screens.
Figure 3-53. Password Prompt Screen
You can specify whether a password is required for the TELNET session or the
console terminal using the Console/Comm Port Configuration screen (see
“
Console/Comm Port Configuration” on page 3-82).
If the console terminal is not password protected, the system ignores the Logout
option.
BayStack Model 410-24T HW:Revx FW:Vx.xx SW:Vx.x.x.x
Password: [ *************** ]
Enter Password: