Nortel BayStack 410 24T - Appendix E Default Settings

309985-B Rev 00
E-1
Appendix E
Default Settings
Table E-1 lists the factory default settings for the BayStack 410-24T switch.
Table E-1. Factory Default Settings for the BayStack 410-24T Switch
Appears in this CI screen Field Default setting
IP Configuration/Setup (page 3-8) BootP Request Mode BootP Disabled
In-Band Stack IP Address 0.0.0.0
(no IP address assigned)
In-Band Switch IP Address 0.0.0.0
(no IP address assigned)
In-Band Subnet Mask 0.0.0.0
(no subnet mask assigned)
Default Gateway 0.0.0.0
(no IP address assigned)
IP Address to Ping 0.0.0.0
(no IP address assigned)
Start Ping No
SNMP Configuration (page 3-13) Read-Only Community String public
Read-Write Community String private
Trap IP Address 0.0.0.0
(no IP address assigned)
Community String Zero-length string
Authentication Trap Enabled
Link Up/Down Trap Enabled
(continued)