Nortel BayStack 410 24T - Figure 1-29. VLAN Port Configuration Screen Example; VLAN Workgroup Summary

Introduction to the BayStack 410-24T Switch
309985-B Rev 00
1-49
Figure 1-29. VLAN Port Configuration Screen Example
VLAN Workgroup Summary
This section summarizes the VLAN workgroup examples discussed in the
previous sections of this chapter.
As shown in Figure 1-30
, switch S1 (a BayStack 410-24T switch) is configured
with multiple VLANs:
• Ports 1, 6, 11, and 12 are in VLAN 1.
• Ports 2, 3, 4, 7, and 10 are in VLAN 2.
• Port 8 is in VLAN 3.
Because switch S4 does not support 802.1Q tagging, a single switch port on each
switch must be used for each VLAN (see “VLANs Spanning Multiple Untagged
Switches” on page 1-42).
VLAN Port Configuration
Unit: [ 1 ]
Port: [ 8 ]
Filter Tagged Frames: [ No ]
Filter Untagged Frames: [ No ]
Filter Unregistered Frames: [ No ]
Port Name: [ Molly's port ]
PVID: [ 3 ]
Port Priority: [ 0 ]
Tagging: [ Untagged Access ]
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.