Introduction to the BayStack 410-24T Switch
309985-B Rev 00
1-31
Removing a Unit from the Stack
If a unit is removed from the stack (therefore operating in standalone mode), the
following switch configuration settings revert back to the settings configured
before the unit became a member of the stack:
• IP address
• Console password
• TELNET password
• SNMP community strings
Stack Configurations
As shown in Figure 1-12, the cascade connectors and cables on the 400-ST1 front
panel provide the ability to stack up to eight BayStack switches. With 400-4TX
MDAs installed in each switch, the stack can accommodate a maximum of 224
switch ports.
Because stack parameters are associated with the base unit (see “
Initial
Installation” on page 1-29), the physical stack order depends on the base unit’s
position and whether the stack is configured stack up or stack down.
To Next Page