Nortel DMS-100 Series Application Guide

DMS-100 Family Switch Performance Monitoring System Application Guide BASE09 and up
2-1
Startup procedures
SPMS operates automatically when SPMS option NTX738AB is present in
the switch. The customer need only set the day for the start of the report
month in the table OFCENG (office parameters).
Setting the day of the month
Access the CI level of the MAP display by typing
>QUIT ALL
and pressing the Enter key.
Access table OFCENG by typing
>TABLE OFCENG
and pressing the Enter key.
Note: If the system responds with a request for a password, contact your
Nortel representative immediately.
MAP response:
TABLE: OFCENG
Position on the required tuple by typing
>POS SPMS_START_OF_MONTH
and pressing the Enter key.
Enter the day for the start of the report month.
Note: The acceptable range of values for START_OF_MONTH is 1 to 28.
The default value is 1.
SPMS automatic report setup
SPMS reports can be automatically generated at any time you specify when
SPMS option NTX738AB is present on the switch and your load is BCS30
or later. The operating company must add the SPMS report to the list of

Nortel DMS-100 Series Specifications

General

Brand	Nortel
Model	DMS-100 Series
Category	Control Unit
Language	English