Notifier RP-1001

To Next Page

To Previous Page

Optional Modules Installation Procedure

RP-1001 15150:F 05/24/2001 23

/(',QWHUIDFH0RGXOH²;/0

Connect the terminals on TB1 of the LED Interface Module to the corresponding terminals of the

RZA-4x Remote Annunciator. The wiring of this module must follow the requirements as speci-

fied under ““UL Power-limited Wiring Requirements” in Section 2.2.

Note: Make wiring connections with system power off. Maximum wire impedance is 50 ohm per

wiring connection.

Connect to corresponding terminals

of the RZA-4X Remote Annunciator.

Front View

Side View Single-gang Box

1 +24V

2 Out#1

3 Out#2

4 Out#3

5 Out#4

6 System Trouble

7 Sound

8 Resound

5=$;IUFGU

5=$;%;FGU

;/0DFGU

Figure 2.12 LED Interface Module

Notifier RP-1001 - Page 23