Notifier RP-1001 - System Operation; System Status LEDs

System Status LEDs System Operation
RP-1001 15150:F 05/24/2001 27
Section 3 System Operation
When applying power to this control unit, apply primary (AC) first, followed by batteries, as
described in “Power-Up Procedure” in Section 2.11.
6\VWHP6WDWXV/('V
Alarm, Trouble and Supervisory LEDs will flash on and off until the event(s) has been acknowl-
edged (TONE or ALARM SILENCE), at which point the LED will illuminate steadily.
$&3RZHU
Green LED that illuminates steadily to indicate
presence of AC power.
6\VWHP$ODUP
Red LED that flashes when an alarm occurs.
5HOHDVH
Red LED that illuminates steadily when release
occurs. After the Discharge Timer has expired, the
LED will flash.
6XSHUYLVRU\
Yellow LED that flashes upon activation of a
supervisory device (such as tamper switch) on
Zone 4.
6\VWHP7URXEOH
Yellow LED that flashes for any trouble condition,
including those associated with optional boards.
&LUFXLW7URXEOH
Yellow LED that flashes for trouble conditions on output circuits (notification and releasing
circuits).
$ODUP6LOHQFHG
Yellow LED that illuminates steadily when the ALARM SILENCE switch has been pushed after an
alarm.
3RZHU7URXEOH
Yellow LED that flashes for low or disconnected batteries and earth fault conditions.
%DWW
Yellow LED that illuminates steadily on motherboard when battery is low or not detected.
(DUWK
Yellow LED that illuminates steadily on motherboard during a ground fault condition.
0LFUR)DLO
Yellow LED that illuminates on motherboard when watchdog timer detects microprocessor failure.
BATT
EARTH
MICRO
FAIL
53B6\VWHP6WDWXV/('VFGU
www.PDF-Zoo.com