Notifier RP-1001 - Secondary Power Connections

Installation Procedure Power-Up Procedure
26 RP-1001 15150:F 05/24/2001
3.
Connect Secondary Power as shown in Figure 2.13.
When the system is powered, the
trouble LED will clear. If the trouble light does not extinguish, refer to Troubleshooting
Table in Appendix C.3.
CAUTION: Observe polarity when connecting battery. See Appendix A for
calculation of correct battery rating.
CAUTION: Batteries contain sulfuric acid which can cause severe burns to
the skin and eyes, and can destroy fabrics. If contact is made with sulfuric
acid, immediately flush skin or eyes with water for 15 minutes and seek
immediate medical attention.



Figure 2.13 Battery Connections
[EDWWZLUHFGU
Red
Black
Black
-
Cable
P/N 75203
www.PDF-Zoo.com