20
128-0521-002
5. Connecting to Power
Warning!
Improper power connection may result in a risk of electrical hazard.
Before plugging the NOVA Nebula lathe into the power source, check that the:
1. The main power switch is turned off.
2. Power source is switched off.
hand side is the European version of the NOVA
wood lathe. Other versions will have
a hard-wired power cable (shown on the image on the right-hand side).
The power cord that is installed on the NOVA Nebula lathe will have a three-prong plug which includes a ground prong.
The plug must be connected to a matching outlet that his properly installed and grounded in accordance with local
electrical codes.
For 110V Outlet Only:
A temporary adapter can be used to plug into a two-pole outlet if a three-prong outlet is unavailable in your environment.
The ground tab on the adapter must be connected to the screw on the outlet for proper grounding. This adaptor should
only be used until a qualified electrician can install a properly grounded outlet.
Note: If an extension cable is required, make sure to check the following:
1. Extension cable gauge is appropriate for the length and voltage.
2. Is the cable properly insulated?
If in any doubt, please contact your local electrician to inspect the cord according to the local electrical standards before
use.
IMPORTANT:
A surge protection device is recommended when using the lathe.
A surge protection device must be rated to at least 15A should be used in countries where 110V are used
as a standard. In countries where 240V is used, a surge protector must be rated to 10A.
Make sure the “0” side of the
rocker switch is pressed in before
connecting the power cable to the
220-240V Version
110-115V Version
To Next Page
Loading...