Nova NEBULA 55600 - Wireless Remote and Motor Parameters

32
128-0521-002
6.7.7 Wireless Remote
The NOVA DVR Wireless Remote II (SKU 55522) can be used for easier to control your NOVA Nebula lathe.
(Refer to wireless remote manual for installation procedures).
Use
key to enter “Wireless Remote” function.
There will be two options available:
 Pair new remote
 Unpair remote
Note: The bottom line shows the ID of the current paired remote.
6.7.7.1 Pair New Remote
Use
or press to pair new remote
Press the key on the remote to pair.
Press
or to confirm
Press
to exit
6.7.7.2 Unpairing Remote
Use
or to Unpair Remote
Press
to confirm, press to cancel the change.
6.7.8 Motor Parameters
Use
to select Motor Parameter,
Press
or to continue,
Or press
to go back.
Use
to select objective parameter,
Use
to edit the parameter, press to confirm or press to go back.
The Content of Parameters
Page 1
Speed Control
Page 2
Voltage Control
Page 3
Temperature
Page 4
Memory
Profile = Normal
V Kprop = 2000
T Heatsink = xx
ᵒ
c
Save to EEPROM
Kprop = 414%
V Kint = 9000
T Threshold = 60
ᵒ
c
Factory Reset
Kint = 3125%
Vd DC Bus = 362v