23
128-0521-002
6.2 Start-up
After turning on the main swich, the lathe will perform a self-check for 15 seconds. The self-checking operation will play a
short piece of music, and a warning message will show up on the screen. The self-check is successful when the LCD displays
the “Ready to run” home menu.
Press ANY KEYs on the HMI panel, The LCD will display the Home page, the lathe is ready to Run Now.
6.3 To Run the Lathe
Press the key once while the LCD is on the Home page, the motor will accelerate to reach the set speed, which will
be displayed on the LCD.
To Next Page
Loading...
Need help?
General
