7
128-0521-002
Lathe Specifications
Metric Imperial
Swing Over Bed
457.2mm 18”
Distance Between Centres
640 mm 25”
Overall Size
1200mm (L) x 600mm (w) x 1250mm(H)
47.2” (L) x 23.6” (w) x 49.2” (H)
Package Size
1280mm (L) x 550mm (w) x 737mm (H)
50.4” (L) x 21.7” (w) x 28.9” (H)
Net Weight
206 Kg ± 2 Kg 454.2 lb ± 4.4 lb
Gross Weight
241 Kg ± 2 Kg 531.3 lb ± 4.4 lb
Headstock
Spindle Thread
M33 x 3.5 RH* 1.25” x 8TPI
Headstock Spindle Taper
Morse Taper #2 (MT2)
Headstock Swivel
360° With detent positions at: -45°, 0°, 22.5°, 45°, 90°, 180°
Headstock Slidable
Sliding Headstock
Spindle Index
24 divisions (15 degrees apart)
Tailstock
Quill Taper
Morse Taper #2 (MT2)
Quill Travel
120mm 4.7”
Hole Through Tailstock
12.5mm 0.48”
Tool Rest
Length
300mm 12”
Shaft Diameter
25.4mm 1”
Motor Specifications
Motor Type
DVR Direct Drive Smart Motor
Motor Speed Range
50 RPM ~ 4000 RPM
Input Frequency
50/60 Hz
Motor Power Output
1.5KW (2.0HP) * 1.8KW (2.5HP)
Input Voltage
110~120V 220~240V
Input Current
15A (max) 10A (max)
* M33 x 3.5 RH thread spindle only available in European models. All other market models will have the
1.25inch x 8 TPI spindle.
* For 110V / 15A, the motor power is derated to 2.0 HP by current limit in software. To get 2.5HP at 110V, the
input power is required change to 220-240V /10A or using dual 110V input.
For Europe, Australasia, UK and South Africa
Directives this equipment complies with:
Low voltage directive (LVD) 73/23/EEC + 93/68/EEC+2006/95/EC
Machinery directive (MD) 89/392/EEC + 91/368 EEC + 93/68/EEC+2006/42/EC
Electromagnetic compatibility directive (EMCD) 89/336/EEC + 92/31/EEC + 93/68/EEC+2004/108/EC
Harmonized Standards applied in order to verify compliance with Directives: EN 61029-1:2009
Low Voltage Directive and Machinery Directive
EN 55014-1:2007
EN 55014-2:2009
EN 61000-3-2:Ed3 2006
EN 61000-3-3:1995 A1 + A2
To Next Page
Loading...
