What to do if the motor and handpiece do not run, or Reset Lamp lights on NSK Laboratory Equipment?
If you have multiple units, try replacing the motor cord. If normal operation resumes, the motor or motor cord may be shorted and need repair. If the issue persists, the control unit may require repair.
General| Brand | NSK |
|---|---|
| Model | Ultimate XL |
| Category | Laboratory Equipment |
| Language | English |
Connect the motor cord plug locator into the Motor Connector, aligning with the groove, and tighten.
Insert the Foot Pedal cord plug locator into the Foot Pedal Connector, aligning with the groove.
Securely insert the power cord plug into the connector at the back of the unit.
Describes the procedure for operating the micomotor using the hand control.
To Next Page
