Equitrac Professional TouchPoint Console Installation and Setup Guide 17
Initial Local Configuration
The first time you power up a new (unconfigured) TouchPoint Console, the Installation Wizard runs automatically to
help you establish communication with the Equitrac Professional DCE server. You must identify the DCE server’s IP
Address, and assign an IP Address to TPC.
The Installation Wizard steps you through three required screens, then automatically reboots TPC to apply the
settings. Follow these steps to perform the minimum configuration necessary to get TPC up and running and ready
for use.
1
Identify the Server IP Address using one of three possible methods. Refer to Identify the Server IP Address on
page 18 for instructions.
2
Assign the TouchPoint Console IP Address by either creating a new instance, or replacing an existing TPC and
using the existing settings. Refer to
Assign the TouchPoint Console IP Address on page 22.
3
Select the Date, Time, and Locale
Synchronize the time and date to match the server settings. You can also change the soft keyboard layout if
required. Refer to
Set the Date, Time and Locale on page 25.
4
TPC reboots automatically.
To access the Administrative options after the reboot, you must login in as administrative user. See
Accessing the
Administrative Options
on page 31.
5
Update the TPC platform and application firmware.
TPC ships from the manufacturer with default versions of the platform firmware and application layer. You must
update the firmware to the latest versions prior to performing server-side configuration. See
Upgrade TouchPoint
Console Firmware
on page 26.
Identify the Server IP Address
Assign the TouchPoint Console IP Address
Set the Date, Time and Locale
Upgrade TouchPoint Console Firmware
3
To Next Page
Loading...