Chapter 3: Initial Local Configuration
28 Equitrac Professional TouchPoint Console Installation and Setup Guide
5
Select the TPC to update from the Ter minal d e vi c e list. The selection highlights.
6
Under Select firmware, click Browse... to locate the TPC firmware update file in the Load firmware dialog.
a
Click Update Firmware. Updating the firmware may take several minutes. The Select firmware list box is
updated with the firmware file name.
b
Click Update Application to locate and update the TPC application update file.
7
Click the Refresh button once the update completes. The TPC information is updated with the new versions in the
Terminal d e v ic e list.
8
After the firmware has updated, select the device from the list and click Restart to force it to reboot.
Discovering TPCs on a subnet
The Terminal Updater can search a specified subnet for valid terminal devices and publish all found devices, as well as
their attributes and status, in the Terminal device list.
1
Click Discover.
2
Enter a valid sample device IP address.
3
Enter the subnet mask and click OK.
The time required to complete the device discovery depends on the subnet range you specify. To stop a discovery that
is in-progress, click Abort.
You can customize the network connection timeout value, if desired. Select the Options > Timeout setting and, in the
Connection field, enter a timeout value (in milliseconds), then click OK. If you enter a connection timeout of 0, the
Terminal Updater replaces this time with the system-defined maximum value (4294967295), which represents
approximately 49 days. Do not enter a value greater than this maximum.
CAUTION: TPC is now configured with basic settings and can communicate with the DCE server. Ensure that you
immediately perform the server-side configuration tasks outlined in the "Configuring TouchPoint Consoles" chapter
of the Equitrac Professional Administration Guide. You may also need to perform further local configuration, outlined
in the “Additional Local Configuration” chapter in this guide.
To Next Page
Loading...