Numatic NX1K - Machine in Use; Off -Aisle Cleaning

13
H
E
A
V
Y
S
O
I
L
I
N
G
To operate, select forward and depress the accelerator pedal.
Vacuum pick-up and water ow will turn on if selected and providing the brush and oor tool are in
the lowered position, the machine will move forward.
Clean water is dispersed evenly via ‘THRU- FEED’ scrubbing brushes.
The waste water is then retrieved by the suction oor tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
After stopping, let the vacuum motor run for 10 seconds to collect any water left in the vacuum
hose, then switch the vacuum motor o󰀨.
On heavily soiled oors use a ‘double scrub’ technique.
First pre-scrub the oor with the oor tool in the raised position, allow the chemicals time to work,
then scrub the area a second time with the oor tool lowered.
If your machine leaves streaks on the cleaned oor,
either clean the oor tool blade or adjust blade height
for optimum performance.
The optional o󰀨-aisle cleaning kit gives added exibility
to the operator.
The kit can be used to clean hard to reach / inaccessible areas.
Remove the vacuum hose from the oor tool and attach to the
o󰀨-aisle kit.
To operate the vacuum, press the vacuum switch on.
Note: Return the hose to the oor tool once nished using
the o󰀨-aisle facility.
Adjusting the blade height.
Set lever to forward.
Water ow rate selection.
Brush deck in lowered position. Floor tool lever in lowered position.
Vacuum switch.
Low
High
Machine Operation
DO NOT OPERATE THE
MACHINE ON INCLINES
THAT EXCEED 11%.
! !
Machine in Use
O󰀨-aisle Cleaning Kit
(Optional Extra Accessory) 606182
NOTE: MACHINE WILL NOT REVERSE WITH
FLOOR TOOL IN THE LOWERED POSITION
! !