Numatic NX1K - Machine Cleaning

14
After use, empty waste water tank using emptying hose and ush out with
clean water.
Remove oor tool vacuum hose ensuring you remove the U-bend clip and ush
out with clean water.
Empty clean water tank, using emptying hose and ush out with clean water.
A
B
C
Remove hoses
Hold the handles and lift the seperator
away from the machine
Hold the handles and lift the seperator
away from the machine
Clean and examine rubber seal during
each clean
Clean and examine rubber seal during
each clean
Remove and clean vacuum shut o󰀨 lter
Press in the 2 retaining handles of the
seperator
Machine Cleaning
!
ALWAYS ENSURE THAT THE MACHINE IS
SWITCHED OFF PRIOR TO ANY MAINTENANCE.
Located in your waste water top tank is
a vacuum shut o󰀨 system, this prevents
suction when the waste water tank is full.
It also prevents foam created by high-
foaming detergents from entering the
motor.
Sometimes the oat vents get clogged
and blocked, clean to ensure correct
operation. Remove debris basket lter and
rinse using clean water, and ret. Ret
both of the vacuum hoses.
!!
IMPORTANT: IF THE DEBRIS BASKET IS ALLOWED TO BECOME CLOGGED,
VACUUM PERFORMANCE CAN DETERIORATE.
!
A
B
C