17
Undo and remove the two retaining knobs.
The TVL850 is equipped with a free wheel
function that will enable the operator to
move / tow the machine. The motor brake
is disengaged by opening the brake arm
on the side of the drive wheel.
Free Wheel and Towing
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND BEFORE
DISENGAGING BRAKE ARM. NEVER DISENGAGE THE BRAKE WHEN
THE MACHINE IS ON A SLOPE / GRADIENT. NEVER TOW THE MACHINE WITH THE
BRAKE ENGAGED AND POWER PLUG CONNECTED! REMOVE BATTERY FUSES
Once the key has been inserted the motor
brake will be fully disengaged.
The machine will now be in full free wheel mode.
Pull the power connector block apart.
Ret the retaining knobs.
Care must be taken when towing;
WHEN TOWING DO NOT EXCEED
AVERAGE SPEED OF 3 KPH.
The machine can be towed from the front
bar as indicated.
When destination place reached,
remove brake disengage key,
connect power plug.
Insert the disengage key between the
brake arm and drive housing.
Your start-up kit includes a brake drive
disengage key (329945).
!!
WARNING!
WHEN THE BRAKE IS DISENGAGED AND POWER PLUG IS DISCONNECTED THE MACHINE IS IN
FREE WHEEL MODE AND HAS NO BRAKE FACILITY, WHEN TOWING THE MACHINE
ENSURE THAT A SUITABLE TOW BAR IS USED.
Remember to remove the brake disengage key when you reach your nal destination / before using the machine.
NOT FOLLOWING DESCRIBED METHOD COULD DAMAGE MAIN CONTROL UNIT AND VOID THE WARRANTY.
!!
To Next Page
Loading...
