Numatic NX1K - 12. Warranty

29
PROBLEM CAUSE SOLUTION
Machine will not operate Low battery charge
Machine is connected and charging
Waste tank full switch stuck or clogged
Key is o󰀨 or missing
Handle safety fuse blown
Charge batteries (page 18/19)
Take o󰀨 charge
Inspect & clean switch inside tank (page 12)
Insert key & turn to operating position
Replace fuse (or contact service engineer)
Vacuum will not operate Missing or blown fuse
Waste tank full switch stuck or clogged
Vacuum switch not engaged
Waste water tank full
Fit or replace fuse (page 5/15)
Inspect & clean switch inside tank (page 12)
Press switch (page 11)
Empty waste water tank (page 14)
Poor water pick-up Waste water tank full
Clogged / blocked vacuum hose
Loose hose connections
Debris basket lter clogged / blocked
Separator lter clogged / blocked
Poor separator seal
Damaged separator seal
Damaged / split vacuum hose
Damaged oor tool blades
Low battery charge
Floor tool incorrectly adjusted
Empty waste water tank (page 14)
Remove and clean (page 14)
Push tight connections (page 14)
Remove and clean (page 14)
Remove and clean (Page 14)
Clean and ret (page 14)
Renew (contact service dept)
Renew (contact service dept)
Renew (contact service dept)
Re-charge batteries (page 18/19)
Adjust oor tool
No brush / scrub function No brushes tted
Brush deck raised
Missing or blown fuses
Check and t (page 7)
Lower brush deck (page 10)
Fit or replace fuse (page 5/15)
Little or no water ow Clean water tank empty
Clean water tank lter blocked / clogged
Water ow not on
Brush deck raised
Fill clean water tank (page 9)
Remove and clean (15)
Switch on water ow (Page 11)
Lower brush deck (page 10)
Machine just ‘stops’ during operating Brush motor fuse blown due to high load Replace fuse & reduce load (page 5/15)
Trouble Shooting
Warning Do not t a replacement fuse link having a higher rating than the value stated on the fuse label.
10. DISTRIBUTOR TAKE-BACK / DISPOSAL
• On the basis of the Battery Directive, the manufacturers take responsibility for financing collection, treatment and
recycling of batteries used in devices.
To this end, batteries must be handed over for disposal to the collection systems established for this under national law.
Disposal of batteries together with household waste is prohibited; batteries must be collected separately according to
type.
• Return the battery free of charge to your NUMATIC servicing dealer for disposal or hand it over to an appropriate public
collection point.
11. CHARGING BATTERIES
• The charger is intended for use only in the machine where it has been installed. The charger is intended for use with the
detachable power cord supplied, the power unit is capable of operating at different voltages without user adjustment. If the charger
is damaged or does not charge anymore, please return to service centre.
CAUTION!
• Check the mains cord regularly for any sign of damage.
• Do not use damaged devices.
• If the mains cord of the charger is damaged, it must be replaced by an original NUMATIC mains cord available from the
manufacturer or service agent.
12. WARRANTY
Lithium-Ion Battery Warranty
Warranty: Commercial Use
a. Batteries are warranted for (3 Years) as standard. *Note: Numatic dealerships outside of the UK may provide longer warranty
periods. Please confirm with your Numatic dealership on purchase of your product.
b. To claim warranty the following details must be supplied
i. Serial number of the machine
ii. Battery date code
iii. Date purchased
iv. Proof of Purchase
v. Maintenance history and charging regime
Failure to use the correct Numatic charger will void your warranty.