12
Pre-cleaning advice.
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the oor
(Fig.27).
Numatic part (629044) Wet Floor sign
(available if required)
Machine Operation
Pre-scrub mode
The TTB 4055/100T has been designed to cope with a variety of oor types and different levels of soiling.
On heavily soiled oors use a ‘double scrub’ technique.
First pre-scrub the oor with the oor-tool in the raised position, allow the chemical time to work, then scrub the area a
second time with the oor-tool lowered.
Floor tool in use
The clean-water / chemical mix is dispersed via the ‘THRU-FEED’ system.
The waste water is then retrieved by the oor-tool.
Overlap the scrubbing path by 10cm to ensure an even clean (Fig.28).
If streaking occurs, wipe the oor-tool blades clean (Fig.29).
Fig.28
Fig.29
Fig.27
Ref to (Fig.25) to raise and lower the oor-tool.
Breakaway oor-tool
The oor-tool design incorporates a breakaway feature.
Allowing it to safely disengage from its mounting should it
become caught on an obstruction, during forward machine
movement.
To re-attach the blade to its holder.
First loosen the retaining knobs on the oor-tool body and slide
onto the holding bracket.
Tighten retaining knobs to nger tight.
Note: Care must be taken to reduce speed when cornering or when manoeuvring around obstacles.
Note: The machine will still reverse with the oor-tool in the lowered position, this could possibly damage the blades.
Raise the oor-tool before reversing.
To Next Page
Loading...
Need help?
General
