8
PLEASE READ BEFORE COMMENCING ANY OPERATION.
After the removal of all the packaging, carefully open and check the contents.
Ensure the Batteries are charged before use.
!
!
1
Using the handle position lever
(Fig.1), move the handle into the
upright position (Fig.2).
4
Fit the isolator key and switch the machine on (Fig.7).
Fig.1
Quick Set-Up Guide
2
Place 50 amp fuse (supplied in the accessory kit) into the fuse holder using
the Maxi Fuse puller provided (Fig.3).
Fig.3
Place the top tank (waste water) into the machine (Fig.5) and connect the
vacuum and oor tool hose (Fig.6).
3
Fig.5
Fig.2
Fig.6
Fig.7
Fig.4
(Fig.4) shows 50 Amp fuse
5
Fill the bottom tank (Clean Water) from a tap or hose pipe using the Flexi-Fill pipe tted to
the ller cap (Fig.8). Add non-foaming cleaning uid as required (See page 11).
The TTB 4055/100T has a water capacity of 40 Litres.
Fig.8
Note:
Great care must be taken to ensure that contaminants
(leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the lling process.
If using a bucket or similar, ensure it is always clean
and free from debris.
To Next Page
Loading...
Need help?
General
