Numatic TTB 4055 - Regular Maintenance; Emptying Waste Tank; Separator; Filter Cleaning; Emptying Clean Water Tank

15
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
! !
After use, empty waste-water tank using
emptying hose and ush-out with clean
water (Fig.37).
Do not attempt to remove top (waste) tank
unless empty.
A
Remove the two hoses to disconnect the separator from the
machine (Fig.38).
Lift off the separator. The separator has a sealing-rubber
which should be examined at every clean-down (Fig.39).
Rinse using clean water.
The TTB 4055T has been designed with ease of use in mind, this included easy stripping-down and cleaning.
Remove the lter tted into the separator and ush with clean water (Fig.40)(Fig.41).
Placed into the top tank is grey lter basket, clean and ush with clean water (Fig.42) (Fig.43).
A
Regular Maintenance
Clean by ushing with clean water if required.
Excess water can be drained using the clear dump hose tted to the rear of
the machine.
Fig.37
Fig.38
Fig.39
Fig.40
Fig.41
Fig.44
Fig.42
Fig.43
Emptying waste tank
Emptying clean water tank
Separator / Filter cleaning
Fig.45
On
Off
Located under the left hand side is a clean
water lter, ensure the clean water tap is
turned off before removing this lter (Fig.45).
Clean and ush with clean water if required.