Nuova Simonelli TALENTO - Safety Instructions

Edition 02 to 12/2013
3.11
SERVICE MANUAL
3.7 BLADE EJECTOR WORM
SCREW AND BLADE
EJECTOR REMOVAL
The blade ejector worm screw is located on
the lower support bracket of the group.
To rimove it:
1 Remove the pouring group (see par. 3.2).
2 Take out the worm screw by removing
the two screws on the base with a phil-
lips screwdriver.
To remove the blade ejector, it is necessary
to:
1 Remove the pouring group (see par. 3.2).
2 Take out the motor (see par. 3.3).
3 Remove the screw on the blade ejector
with a 3 mm allen key.
4 Slide out the blade ejector, turning the
shaft.
5 Slide the shaft from the bottom.
When refitting, the engineer needs to:
1 Reposition the shaft.
2 Reload the spring by one and a half turns
using the blade. Add in the screw soft
loctite.
3 Tighten the 3 mm allen screw.
Fig. 28
2
Fig. 29
3
Fig. 30
4
5
4
Fig. 31