Nuova Simonelli TALENTO - Changing the Condenser

Edition 02 to 12/2013
8.8
SERVICE MANUAL
8.5 CHANGING
THE CONDENSER
To access the condenser, the service engineer
will have to:
1 Switched off the machine.
2 Remove the rear panel by taking out the two
screws with a phillips head screwdriver (A).
3 remove the right side panel too.
To remove the capacitors:
1 Take off the protective cap.
2 Disconnect the faston.
3 Using a 13 mm wrench, remove the nut on
the side panel of the condenser.
4 Remove the condenser itself.
WARNING
Risk of electrical shock.
Do not touch the capacitor’s terminals.
2
1
A
Fig. 23
1-2
Fig. 24
Fig. 25