Need help?Do you have a question about the Nureva SPAN and is the answer not in the manual?
Read all instructions before installation and keep for future reference.
Warnings about projector Class 2 and touch module Class 1 laser devices.
Precautions for operating, handling, cable management, and weight limits.
Specifies required space, height, and width for system setup.
Measure and mark the system centerline on the wall for bracket placement.
Referencing installation drawings to mark wall mount plate holes.
Marking remaining wall mount plate holes from the centerline.
Ensuring the wall mount plate is level and attaching it securely.
Attaching the projector plate to the projector with screws.
Adjusting the wall mount boom length and tightening bolts.
Securing the wall mount boom to the wall mount plate.
Mounting the projector onto the boom using provided screws.
Attaching the touch module unit to its bracket securely.
Securing the NAM to mounting brackets using provided screws.
Ensuring the IPv4 Ethernet port is correctly enabled.
Power on the NAM, projector, and PC to begin adjustments.
Using mount adjustments to straighten and square the projected image.
Achieving proper overlap for multi-projector or gap for other configurations.
Using the side slider to bring the projected image into sharp focus.
Follow the WhisperTek surface installation guide.
To Next Page
General