Nvidia Quadro K5000 User Manual

Quadro K4000/K5000/K6000 SDI DU-05337-002_v01 | 33
Chapter 04 : Linux—Using the Graphics to Video Out Control Panel
• Frame Lock: The SDI output will be synchronized with the timing chosen from
the SDI signal format list.
This list is limited to timings that can be synchronized with the detected external sync
signal.
3 Check the Enable Composite Termination check box if
• the system is a standalone system synchronized to a house sync signal, or
• the system is the last in a chain of systems connected to the same house sync signal.
For more information regarding genlock and frame lock, see the section “Synchronizing
the SDI Output to an External Source” on page 41.
Step 3: Choose the Video and Data Formats
1 Click the Graphics to Video Out tree item from the side menu.
2 Specify the video format.
Click the Video Format arrow and then click the signal format you want to use.
Video Format controls the video resolution, field rate, and SMPTE signalling
standard for the outgoing video stream.
Note: Only those resolutions that your monitor supports appear in the Video Format list.
Your options for this setting also depend on which Sync option you chose in the
previous step.
• If you chose genlock synchronization, the sync source controls the output video
format. The list box will be grayed out, preventing you from choosing another
format.
• If you chose frame lock synchronization, only those modes that are compatible with
the detected sync signal will appear in the Output Video Format list.
3 Specify the Data Format

Nvidia Quadro K5000 Specifications

General

CUDA Cores	1536
Memory Size	4 GB
Memory Type	GDDR5
Memory Interface	256-bit
Memory Bandwidth	173 GB/s
Max Power Consumption	122 W
DirectX	11
OpenGL	4.5
Architecture	Kepler
GPU	GK104
Bus Interface	PCI Express 3.0 x16
Form Factor	Dual Slot
Display Connectors	2x DVI, 2x DisplayPort
Interface	PCIe 3.0 x16
Max Resolution	3840x2160
Outputs	DisplayPort + DVI-I