Nvidia Quadro K5000 User Manual

Quadro K4000/K5000/K6000 SDI DU-05337-002_v01 | 27
Chapter 03 : Windows–Using the Graphics to SDI Control Panel
Enabling Multiple SDI Cards
On systems with more than one NVIDIA Quadro SDI card, the Manage SDI Output
Settings page lets you configure the SDI output for each card. Before you can do this, all
cards must be enabled.
To enable multiple SDI cards
1 Make sure a display is connected to each SDI card that you want to enable.
2 Open the Windows Display Properties page.
a Right-click the desktop, then click Properties from the pop-up menu.
b Click the Settings tab.
3 Determine which monitor icon corresponds to the graphics card that you want to
enable.
There should be two monitor icons for each graphics card in the system. Typically,
monitors 1 and 3 are connected to one graphics card and monitors 2 and 4 are
connected to the other. For example, if monitor 1 is already attached, then monitor 2
would be grayed out, indicating that it is connected to the graphics card that is not yet
enabled.
4 Right-click the grayed-out monitor icon corresponding to the graphics card you want
to enable, then click Attached from the pop-up menu.
- or -
Click the monitor icon, then click the Extend my Windows desktop onto this monitor
check box.
5 Click OK.
You can now configure the SDI output for each SDI card as described in Basic SDI Setup.
Open the View System Topology page (see “Viewing the SDI Connection Status Using
the Topology Viewer” on page 29) to verify your display-to-graphics card connections.

Nvidia Quadro K5000 Specifications

General

CUDA Cores	1536
Memory Size	4 GB
Memory Type	GDDR5
Memory Interface	256-bit
Memory Bandwidth	173 GB/s
Max Power Consumption	122 W
DirectX	11
OpenGL	4.5
Architecture	Kepler
GPU	GK104
Bus Interface	PCI Express 3.0 x16
Form Factor	Dual Slot
Display Connectors	2x DVI, 2x DisplayPort
Interface	PCIe 3.0 x16
Max Resolution	3840x2160
Outputs	DisplayPort + DVI-I