NXP Semiconductors FS4500/FS6500 evaluation boards
KTFRDMFS4500-FS6500EVMUG
FS4500/FS6500 evaluation boards All information provided in this document is subject to legal disclaimers. © NXP B.V. 2017. All rights reserved.
User guide Rev. 4.0 — 12 June 2017
10 / 34
4.5.2 Jumper definitions
Figure 5 shows the location of jumpers on the evaluation board.
Table 5 describes the function and settings for each jumper. Default jumper settings are
shown in bold text.
Figure 5. Jumpers
Table 5. Jumper definitions
Jumper Description Setting Connection/Result
[1–2] VDDIO referenced to V
CORE
or P3V3_KL25ZJ6 VDDIO selection
[2–3] VDDIO referenced to V
CCA
J7 Debug mode [1–2] ON:Debug mode OFF: normal mode
4.5.3 Test point definitions
The following test points provide access to various signals to and from the board.
To Next Page
Loading...
