NXP Semiconductors FS4500 - EVM Overview

NXP Semiconductors FS4500/FS6500 evaluation boards
KTFRDMFS4500-FS6500EVMUG
FS4500/FS6500 evaluation boards All information provided in this document is subject to legal disclaimers. © NXP B.V. 2017. All rights reserved.
User guide Rev. 4.0 — 12 June 2017
4 / 34
3.4 EVM overview
The EVM contains two boards:
• FRDMFS4503CAEVB or FRDMFS6523CAEVB or FRDMFS6522LAEVB: These
are the evaluation boards available for the FS6500 / FS4500 SBC. The hardware is
described in Section 4.5 "Getting to know the hardware". This document refers to these
boards as EVBs.
• FRDM-KL25Z: This board contains the KL25Z MCU. It is plugged into the EVB by
means of the Arduino
™
connectors on both boards. The FRDM-KL25Z manages
communication between the EVB and a host PC, allowing users to access the EVB's
on-board device features and registers. For more information on the FRDM-KL25Z see
Section 11 "References"