NXP Semiconductors FS4500 - Use Case Example; Using the Flexgui

NXP Semiconductors FS4500/FS6500 evaluation boards
KTFRDMFS4500-FS6500EVMUG
FS4500/FS6500 evaluation boards All information provided in this document is subject to legal disclaimers. © NXP B.V. 2017. All rights reserved.
User guide Rev. 4.0 — 12 June 2017
24 / 34
aaa-025556
6. Send the register configuration file to the FS45xx/FS65xx by clicking the Send
Sequence button.
aaa-025645
7.2 Using the FlexGUI
To start the FlexGUI, do the following:
1. Configure the hardware as described in Section 6.1 "Connecting the hardware".
2. To launch the FlexGUI, execute the .bat file created in Section 9 "Appendix B:
Installing the FlexGUI" .
7.3 Use case example
This example assumes the user has configured the hardware as shown in Figure 13 and
put the evaluation board into debug mode by placing a connector on jumper J15 (see
Section 6.1). After launching the FlexGUI, the example configures registers to disable
IO_23_FS safety mode, disable the watchdog and release the FSx pins.