NXP Semiconductors FS4500/FS6500 evaluation boards
KTFRDMFS4500-FS6500EVMUG
FS4500/FS6500 evaluation boards All information provided in this document is subject to legal disclaimers. © NXP B.V. 2017. All rights reserved.
User guide Rev. 4.0 — 12 June 2017
25 / 34
• Create an Excel file configured as shown in Table 15. For details on creating an Excel
register configuration file, see Section 7.1 "Creating and using a register configuration
file"
Table 15. Use case register configuration Excel file example
HEX Registers Comment
C465 BIST Execute ABIST2_VAUX and ABIST2_FS1B
D60C SF_OUTPUT_REQUEST Close S1 switch between V
PRE
and VPU_FS to enable
FS1B pull up
CB0C INIT_FSSM IO_23_FS Disabled
8900 INIT_INT Close main machine initialization sequence
D34D WD_refresh_0 1st Watchdog refresh answer
D29B WD_refresh_1 2nd Watchdog refresh answer
D237 WD_refresh_2 3rd Watchdog refresh answer
D26E WD_refresh_3 4th Watchdog refresh answer
D2DC WD_refresh_4 5th Watchdog refresh answer
D2B9 WD_refresh_5 6th Watchdog refresh answer
D372 WD_refresh_6 7th Watchdog refresh answer
D4A7 RELEASE_FSxB Release FS0B & FS1B pins
• To use the register configuration file, open FlexGUI, then load the register configuration
file and send it to the evaluation board .
• FlexGUI can now be used to read or write any authorized registers.
Below is an example of registers contents:
To Next Page
Loading...
