NXP Semiconductors FS4500 - Creating and Using a Register Configuration File

NXP Semiconductors FS4500/FS6500 evaluation boards
KTFRDMFS4500-FS6500EVMUG
FS4500/FS6500 evaluation boards All information provided in this document is subject to legal disclaimers. © NXP B.V. 2017. All rights reserved.
User guide Rev. 4.0 — 12 June 2017
23 / 34
7.1 Creating and using a register configuration file
Creating an Excel register configuration file allows the user to initialize the evaluation
board MCU with a predefined set of register values. To create a register configuration
file, do the following:
1. Open a new Excel spreadsheet file and label the first three columns in row 1 hex,
registers and comment. Notice that the first two columns —hex and registers— are
mandatory. The comment column is optional.
2. In the hex column (column A), enter the data or address to be assigned to each
register. The address and data must be contained in two bytes and must be
expressed as a hexadecimal value. Enter one row per register.
3. In the registers column (column B), enter the register name associated with the value
in the hex column.
4. In the comments column (column C), enter any comments desired. Data in this
column is not processed by the FlexGUI. The image below illustrates a typical register
configuration file.
Mandatory
Optional
aaa-025557
5. Launch FlexGUI. When FlexGUI opens, click the Load Sequence button to load the
register configuration file.